← Back to 2Cut
Choosing cut files for laser, plasma and waterjet
A cutting machine follows lines, not pixels. A good cut file is a clean set of vector paths: lines and curves that the machine can trace. This guide covers what to look for when you pick a file and what to check before you cut. Every machine and material is different, so treat the numbers below as rough starting points and test on scrap.
SVG or DXF?
- DXF is the CAD format. Nearly all CNC, plasma and waterjet software opens it. Be careful with size: DXF files do not always say whether their units are inches or millimeters, so measure the part after you import it.
- SVG is common in laser and craft software and in drawing programs such as Inkscape. It usually keeps its size and colors, which makes it easy to tell cut lines from engraving.
- Either can be converted to the other. If a site offers both, take the one your software opens most cleanly.
What suits your machine
- Laser (diode or CO2): a thin cut width, roughly a tenth to a third of a millimeter, so fine detail and small holes work well. Thin lines are cut lines, and filled shapes are usually engraved. Wood, acrylic, leather and card are common materials.
- Plasma: a much wider cut, often more than a millimeter and a half, and it needs a place to start each cut. Avoid thin details and tiny holes. Detail should be larger than the material is thick. Designs with islands, such as the middle of an "O", need bridges so the center does not fall out. Look for files described as stencil or plasma ready.
- Waterjet: a cut width of around a millimeter. It handles thick material and almost any kind, but very fine detail and sharp inside corners are limited by the nozzle.
Check before you cut
- Closed paths. Shapes that are meant to be cut out should be closed, with no gaps.
- No duplicates. Doubled-up or overlapping lines are cut twice, which burns or wastes time.
- Real size. Set the part to the size you want and measure it. Do not trust the file's stated size.
- Islands and bridges. Pieces that would drop out need small bridges, especially in stencils and lettering.
- Material thickness. For slot-together models, the slot width has to match your material. Cut one test piece first.
- Test on scrap. Always cut one small test before committing to the good material.
Flat files and 3D files
Some results are 3D models, such as STL files made for 3D printing or for carving a relief on a router. They are not flat cut files. 2Cut lists items that look like this at the bottom of the results. Some STL files are really flat shapes and can still be useful, so look at the preview and the description.
How 2Cut helps
- Ready to cut shows only files that say they are for laser, plasma, waterjet or CNC cutting, and lists the best matches first.
- Output lets you choose cutting, engraving or silhouette files.
- Every preview opens the file on its own site, where you can see its formats and its license.
This guide is general advice, not a substitute for your machine's manual or your material supplier's guidance. Wear the right protective gear, and never cut materials that release dangerous fumes.
Guides · Licenses explained · About · Privacy · Terms