Getting a cut file ready: scale, kerf, closed paths and bridges

Most failed cuts come from the file, not the machine. This checklist catches the common problems.

1. Set the size

Open the file in your design or CAM software and check the dimensions. Scale to the size you want, and keep the proportions locked unless you mean to stretch the design. If the numbers look wrong by a factor of 25.4, the file is probably in inches or millimetres and being read the other way.

2. Understand kerf

Kerf is the width of material the cut removes. A laser's kerf is small, plasma's is wider, and waterjet's is in between. It matters most for parts that fit together: slots may turn out loose, and tight fits may need a small allowance. Cut a test joint in scrap and measure it.

3. Close your paths

Each shape to be cut out should be a closed loop. Use your software's join or close function. Delete stray points and tiny scraps of line left over from the original drawing.

4. Remove duplicates

Overlapping lines cause double cuts, burning and wasted time. Most programs have a "delete duplicates" or "weld" tool.

5. Add bridges to islands

Letters like O, A, B and D have a middle piece that is surrounded by the cut. Once cut, it drops out. Stencil designs add small bridges that hold the centre in place. If you are cutting a sign meant to hang as one piece, a design with bridges or a backing plate does the job.

6. Mind the minimum detail size

As a rule of thumb, avoid holes or slots much smaller than the thickness of your material, especially with plasma. Thin bridges and narrow points can burn away or snap.

7. Order the cuts sensibly

Inner details first, outer outline last, so the part stays held in the sheet while you cut it. Good CAM software does this for you, but check the order.

8. Test on scrap

Run a small piece, or the same file at reduced size, in cheap material. Adjust speed and power from there.

Safety

Use the right extraction, eye protection and fire precautions for your machine and material. Never cut unknown plastics, since some release dangerous fumes. Follow your machine maker's instructions.